Results 1 to 7 of 7

Thread: Carb problems

Hybrid View

  1. #1

    Array
    Status
    Offline
    Join Date
    07-22-2011
    Posts
    4
    Location

    Mount Bethel, PA
    Vehicle

    1988 Dodge Ram 50

    Carb problems

    My truck was acting like it was running out of fuel with a load on engine ie..going up a hill. It got progressively worse. Determined it was the carb bowl vent by running it without air cleaner. It is better, but still lacks power. Looking for an inexpensive solution.
    Thanks, Andy

  2. #2




    Array
    Status
    Offline
    Join Date
    03-20-2011
    Posts
    4,851
    Location

    Pittsburgh, PA
    Vehicle

    1980 Dodge D-50
    Engine

    G54B
    Which carb are you running and what motor?
    Pennyman1
    The best Dodge that Dodge never made
    Living the D-50 lifestyle since 1980

  3. #3

    Array
    Status
    Offline
    Join Date
    07-22-2011
    Posts
    4
    Location

    Mount Bethel, PA
    Vehicle

    1988 Dodge Ram 50
    Quote Originally Posted by pennyman1 View Post
    Which carb are you running and what motor?
    The truck is a 1988 2 wheel drive w/ the 2.0, and stock carb.

  4. #4




    Array
    Status
    Offline
    Join Date
    03-20-2011
    Posts
    4,851
    Location

    Pittsburgh, PA
    Vehicle

    1980 Dodge D-50
    Engine

    G54B
    check the vacuum lines in the box on the wheelwell on the pdrivers side - common place for hoses to rot and/or have critterws eat the lines. The box contains sensors that control the computer controlled carb.
    Pennyman1
    The best Dodge that Dodge never made
    Living the D-50 lifestyle since 1980

  5. #5

    Array
    Status
    Offline
    Join Date
    07-22-2011
    Posts
    4
    Location

    Mount Bethel, PA
    Vehicle

    1988 Dodge Ram 50
    Thank you Pennyman1, I will check that out.

  6. #6

    Array
    Status
    Offline
    Join Date
    07-22-2011
    Posts
    4
    Location

    Mount Bethel, PA
    Vehicle

    1988 Dodge Ram 50
    Checked the box, all appeared fine. Ended up putting a weber carb on it. Now I am just waiting for the regulator to come in so that I can finish the job.
    Penneyman1, thanks again for the advice!

  7. #7

    Array
    Status
    Offline
    Join Date
    03-26-2011
    Posts
    409
    Location

    Portland, OR
    Vehicle

    1986 Dodge Power Ram 50
    Engine

    G54B
    Can I suggest a Carter P4070 fuel pump (check Rickdees post to install with a relay)? Pain to install, but will make the Weber happier (I also suggest a bigger fuel filter or a primary/secondary arrangement). You can use some scrap sheet metal to blank the mechanical hole (use a gasket as a template, reuse the spacer and some epoxy to create the plate, grey RTV and a new gasket to seal it) or just remove the cam arm.

Tags for this Thread

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •