So I just got this truck running after a while, I put another motor in it, and runs great again.
I used the original carb because the one on the new motor was seized.
So it's running like it did before.
If I only use 1/4 throttle it drives around great!
Starts great and the choke works good.
But if I give it anymore throttle it seams like it hesitates and you feel the truck slow down and if you floor it then it will just slowly accelerate. So lack of power "bad! As in on a freeway on ramp I only hit 40mph by the time I'm on the freeway"
So I need someone to help me because I am a complete noob at carbs. I can do anything else. And I am a visual learner. I have a Haynes manual and it's like Spanish to me.
Anyone near ogden utah area?
It has new plugs, wires, cap and rotor, ignition timing set to 5*, new air filter, cleaned egr and ports, all vac lines are good "even in the litte silver box on fender".
New clutch, syn oil change, trans fluid, clutch cable adjusted, throttle cable adjusted correctly!
I just don't know carbs well enough.
I would like to stick with an oem carb because I want this truck to stay original.
Any help would be fantastic! Thanks!
Here's the truck