Results 1 to 5 of 5

Thread: Fuel injection issue

Hybrid View

  1. 02-24-2015 02:34 PM #1
    MightyMe
    DEAD USER

    Array
    Status
    Offline
    Join Date
    07-24-2014
    Posts
    6
    Location

    South Carolina
    Vehicle

    1990 Mitsubishi Mighty Max
    Engine

    4G64

    Fuel injection issue

    1990 MM 4G64 with 225,000 miles. I am chasing a rough idle and poor drivability. Pulled all four injectors and sent them off to be cleaned and flow tested. Before and after the cleaning, the number four injector was not flowing. I placed all four injectors in plastic bottles and cranked the engine. 1,2,3 were all equal but 4 was dry.

    at this point im concerned about a wiring harness issue. What should i do?
    Reply With Quote Reply With Quote
  2. 02-24-2015 03:31 PM #2

    noahwins's Avatar
    noahwins
    Masters Degree

    Array
    Status
    Offline
    Join Date
    08-11-2012
    Posts
    1,199
    Location

    Oakland, CA
    Vehicle

    1989 Mitsubishi Mighty Max
    Engine

    G63B
    As always with the early 2.4s, has the ECU been rebuilt?
    Reply With Quote Reply With Quote
  3. 02-24-2015 05:09 PM #3
    MightyMe
    DEAD USER

    Array
    Status
    Offline
    Join Date
    07-24-2014
    Posts
    6
    Location

    South Carolina
    Vehicle

    1990 Mitsubishi Mighty Max
    Engine

    4G64
    yes, i looked and it has a sticker from a rebuilder in Florida on it
    Reply With Quote Reply With Quote
  4. 02-24-2015 06:17 PM #4

    noahwins's Avatar
    noahwins
    Masters Degree

    Array
    Status
    Offline
    Join Date
    08-11-2012
    Posts
    1,199
    Location

    Oakland, CA
    Vehicle

    1989 Mitsubishi Mighty Max
    Engine

    G63B
    Did you switch injectors around to rule out the #4 injector itself being bad?
    Reply With Quote Reply With Quote
  5. 02-25-2015 05:41 AM #5

    LSR Mike's Avatar
    LSR Mike
    Land Speed Record Holder


    Array
    Status
    Offline
    Join Date
    04-04-2011
    Posts
    712
    Location

    Columbus, OH
    Vehicle

    1992 Mitsubishi Mighty Max
    Engine

    Other
    The wiring harness has a connector in the engine bay on the firewall Passenger side, near the top. Get a meter and Ohm it out to #4. only 2 wires.

    http://www.mmeierle.com/MPI24LCircuit-1.jpeg
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Tags for this Thread

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules