Using after market wiring harness
I am using an 89 Ram 50 engine and automatic trans G54B 2.6 for a project car.
The car I am building is stripped down (think 1914 Stutz Bearcat)
The present car has a computer and all sorts of wires and tubes.
I want to run a simple after market wiring harness and a simpler 2 barrel carb.
Does anybody have any suggestions?
I have found a Pertronx igniter II unit and have been told that they have a unit that will match with a 1987 2.6 Chrysler Raider.
Is the 87 Raider and the 89 Ram50 the same?
Tags for this Thread