heres a few pics.. they are current as of today...

motor mounts off and cleaned up, drivers side uca mount started.

damn i have so much more work to do....

thanks for looking..

please comment, like, dis=like, leave feedback please. thanks









4doorciv wrote:
I'm sorry but I don't quite understand the consept of the square tubing designed like that. Also, removing the engine mounts tells me you won't be using the 2.4 anymore, or you are going to do a body drop and modify where the engine sits in the bay.

the square tubing is used to mock up and fab to the original two bolt holes that are from the factory locations. it looks like it does because its just scrap pieces that i had and didnt want to waste the money on buying more.... There are many other ways to do this. This being my first build that is this far in depth i chose to go this route.

this keeps the two points in the right spots while i build to them and come up with my design. then allows me to build them and not lose the original positions.

the motor mounts were removed because i am going with a sbc once i am done and satisfied with my frame and all its work still to come.

I am going to body drop it to the pinch...well atleast to the pinch but most likely to the rockers. I also z'd the frame. this helps with laying out ..it brings the cross member and the steering linkage components that are below the frame to be raised up so the truck truly lays out and doesnt rest on the components that are naturally below the frame rails.