-
Auto lash adjuster tool
I'm planning to install my jet valve eliminators tomorrow. Looks like I need to remove the rocker arm assembly to get at the valves. The service manual shows a tool that looks like a c clip that holds the lash adjusters in place while the head is off. Are those a must? Is there a suitable substitute for that tool so my adjusters don't go clunking on the ground?
-
-
Thanks Mike. Looks like that was a non issue. Although the FSM shows that I'm supposed to have these, the adjusters on the rocker arms were mechanical. The bigger issue was the broken rocker arm retaining bolts on either side of the #3 exhaust valve. Looking for advice on that now. Please see my other post.
-
Correction. The broken bolts were on either side of the #3 INTAKE valve rocker arm, not the exhaust valve.
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks