ok so i looked into the EDIS and while it can be a nice set up it's just to much computers for where i'm wanting to go with this build. i was actually super excited to do a carb set up with no emissions or ECU's

took some mock up pictures with the spacers on the intake on the motor that's in the truck right now (not going to be used)


and this last one is to show the distance from the spacers to the hood scoop hole in the hood (i still need to trim the excess bolts, i know i know) but this is where i need some help, anyone wanna measure their weber from the base to the top of the air filter and let me know what you get? i just don't wanna run out of room