Quote Originally Posted by Sgt Mitsu View Post
I got a new jet valve and jet valve plug kit finally.

Going to replace the working new jet valve just to see if it fixes the issue.

The jet valve was burned at the combusion end and not sealing the passage off.

I'm going to wait and install the plugs at an engine rebuild I plan on doing soon.

Still driving it and it runs fine just have to empty the catch bottle i made every time i do drive it.

Wish me luck.

how is the pcv valve?

If your getting that much oil through to a catch can then your sucking oil from the valve cover I would think. Catch cans can also catch residual water in engine also. How is your catch can conected. Valve guide seals could be another cheaper fix if oil is seaping into chambers. Bottom line would be to do a compression check also. Check and make sure your compression isn't under spec too far between cylinders.