Results 1 to 2 of 2

Thread: Hey gurus, would 1990 B2600i 12 valve fit in our trucks?

  1. #1

    Array
    Status
    Offline
    Join Date
    08-11-2012
    Posts
    1,199
    Location

    Richmond, CA
    Vehicle

    1989 Mitsubishi Mighty Max
    Engine

    G63B

    Hey gurus, would 1990 B2600i 12 valve fit in our trucks?

    Is this still a G54B or did those stop going into Mazda B-Series in 1988? A woman just came into the shop and said her husband wanted to sell it for a song. Truck ran great. Even better is it was a manual and there's no emission crap on it.

    The layout was swapped, intake on passenger side, exhaust on driver's side. Other than that it looked like a regular Mitsu 2.6, but with injectors and rails.

    Anyone know?

    Is the 12 valve head the crummy MCA thing?

  2. #2



    Array
    Status
    Offline
    Join Date
    03-20-2011
    Posts
    4,115
    Location

    Pittsburgh, PA
    Vehicle

    1980 Dodge D-50
    Engine

    G54B
    the 1990 mazda 2.6 is a mazda motor based on the mitsu design. Go to B2600.com for more info on it and our 2.6 mitsu motors. Mazda did run the mitsu 2.6 in 88 and 89 - the 5 spd tranny has a removable bell housing that allows the use of the RX-7 or other trannies to be bolted upto the truck 2.6. Not sure if it is a good id.ea to swap as intake / exhaust are swapped
    Pennyman1
    The best Dodge that Dodge never made
    Living the D-50 lifestyle since 1980

Tags for this Thread

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •