so after a night of heavy drinking with a buddy months ago we decided we were gonna try to do some work to my old truck... 89 power ram... it sounded like a good idea at the time but my mechanic skills are very limited as u will notice... anyways got everything to make it new under the hood/drivetrain i.e neew non jet head water/fuel pump yada yada yad the list continues on and on... anyways i listened to him as far as which specialty tools to buy and wound up with the "spaceship" pully remover... only problem is the are no holes in the ballancer... im gonna go out on a limb and say i just need an arm puller instead??? ... here is the issue i have a timing chain kit so i need the ballancer off... seems simple enough just would prefer advice on removal and install so i can b for sure b4 i rip into it...