How much did all this cost? I want to replace my mechanical fuel pump and want to do it right, but try not to be expensive? Or how do I do it cheaply?

Quote Originally Posted by Acuta73 View Post
Got the Schneider PN, will order as soon as I can source some damn mech rockers....

Got all my new fuel system together. -6 AN fittings and line. Overkill? HELL yes! There is NO kill like overkill! I want this truck to be bomb proof, this system will be.

9ft -6 AN sleeved hose (more than I need, but I hate being short)

25ft 5/16 hard line: only came in 25ft length and I needed to increase my return line size to make this work, so now both lines get replaced.

3x tube to hose adapters (hard line)

3x female -6 AN to hose (hard line)

2x 45° 3/8 NPT to -6 hose (canister in/regulator out)

1x 90° 1/4 NPT to -6 hose (pump out)

1x 1/4 NPT to -6 male nipple (pump in)

1x 90° Female -6 to Female -6 swivel (pump in)

1x 3/8 NPT union (connects canister and regulator)

1x 3/8 plug (for canister)

1x 3/8 to 1/8 NPT reducer bushing (for pressure gauge)

1x 90° 1/8 F to 1/8 M NPT (for pressure gauge)

Banjo Weber -6 AN fuel fitting

Stainless mounting hardware

Carter silencing kit (with lots of extra rubber gromets)

Billet 100 micron -6 AN pre filter

10 micron high-flow canister filter (HELLUVA lot bigger than I thought it was gonna be...)

Mallory 4309 3-12lb pressure regulator with return

Summit 15lb liquid filled fuel pressure gauge

Relay, 10ga wire, and breaker

thread seal tape

(pesky beer bottle migrated in there for scale)



Also got my Tuff Pan and a pair of manual hubs


Tuff Pan is more overkill, but again, bomb proof....