Here is what I am playing with now. I need to swap to 5 lug for better wheel selection and a few other reasons. The Tacoma hubs work great, except when placed on the Might Max spindle, the offset increases by almost a half inch. THat translates into a +48mm offset wheel needed to sit flush. That's not likely to find in the "large selection" category.


My solution - change the hubs. Here is a rough sketch with the corrected geometry.

MM Hub Wireframe.jpgMM Hub Solid.jpg

This will likely change again so I can correct it for rotor placement. The Tacoma hub requires you to space the caliper some 0.4XX inches to mate with the Tacoma rotor. I will not use the Tacoma rotor (I'm using a 3KGT rotor), so I need to correct the hub offset to fit rotor offset without spacing the caliper. These will eventually be machined from a billet of 6061 aluminum.