Header for 2.4 progress, hopefully...

[thillskier]

I just talked with Dominick at DG about status of paired port header, and he is going to ship the prototype to me for evaluation and tweaking for fitment. Its the "rough prototype" one so not pretty, but it may be less pretty after we make it fit! But, to me gorgeous, as it will be installed on MY truck! Its a 2 1/4 collector, so that's the size exhaust I will PROBABLY run (unless I decide to go up in case of later turbo or diesel, etc. mods... Once adjusted to fit, I will take some photos, and give a butt dyno evaluation, then ship it back (unless its minor tweaking and he says to keep it on, of course). Doubtful, knowing MY luck!! hehe SO we should have some good news re header for 2.4 truck guys soon...

[pennyman1]

that seems small for the collector - how long will it be?

[thillskier]

mot sure, just what he said...maybe for anti reversion (more low end tq?) Its not here yet...

[camoit]

It was built to have anti reversion built in already. The problem is not having a truck here I can get to him. He won't be back from Bonneville for 2 weeks.
What we need is someone to hack it up and just stick the thing on there using any junk they can. Then send it back to have the final one built. The reason we are not going to make any adjustments to the one we have is because it's not worth the time. It would be a hack job at best. And he does not do that kind of work. I sent you a PM give me a call so we can discuss what we are going to do.