rear axle oil seal

[BradMph]

The puller is a plate, really not a puller in the sense, but it achieves the same outcome. Most the time you can use a chisel to crack the ring off, If you want to keep the ring intact, try applying heat to the ring to expand it and then give it a sharp hit to free it. That's probably the only way to get it free off the axel.


Take a look at one of my past threads when I had a bearing go out. Though I had some idiot at a garage screw things up, I did do some resourcing on the subject. The puller can be made from a plate of steal and drilled holes to force the bearings and items off the axel.

http://www.mightyram50.net/vbulletin...-Replace/page3
Check Post #52


images.jpgimages.png