Results 1 to 3 of 3

Thread: Homemade Intake

  1. #1

    Array
    Status
    Offline
    Join Date
    05-18-2013
    Posts
    4
    Location

    Dyess AFB, Texas
    Vehicle

    1993 Mitsubishi Mighty Max
    Engine

    4G64

    Homemade Intake

    Not really sure if this is the right area but here it goes

    found out an adaptor for a 3000GT MAF sensor works to put a cone filter on the mighty max works

    my old box was broken so I spent the $50 to build a new intake

    I think it looks a lot better then the giant stock air box


  2. #2

    Array
    Status
    Offline
    Join Date
    03-28-2013
    Posts
    34
    Location

    los angeles
    Vehicle

    1994 Mitsubishi Mighty Max
    Engine

    4G64
    looks good man. try to make a heat shield/box it off from the rest of the engine bay so it won't suck in hot air. i'm going to end up doing this sometime in the future. i'm also going to cut a hole in the heat shield and run this piece from the old stock setup into it
    Untitled-1.jpg

  3. #3

    Array
    Status
    Offline
    Join Date
    05-18-2013
    Posts
    4
    Location

    Dyess AFB, Texas
    Vehicle

    1993 Mitsubishi Mighty Max
    Engine

    4G64
    that's my plan...I have a heat shield from my short ram off my mazdaspeed 3 that I might try to use

Tags for this Thread

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •