Working on some fine tuning and odds and ends that need to be done.

*Adjusted the valves, this time using a better method of degree of the cam shaft. Exhaust valves were needing adjustment a bit more then the intake this time.
*Started to reinforce the header from tapping the frame on occasion by using a bracket off the old exhaust system. Putting a rubber grommet between it and the frame should suppress the tapping and vibration.
*Started wire brushing rims to give them and update.

ToDo
*Need to reconnect the 87 digital clock on my 86 where it is installed in the installed Ram50 console.
*Install 2 dash lights into my oil pressure and voltage gauges that are installed in the console as well.
*Fix box door using a strip of leather for a hinge method since the factory cheap plastic has worn completely.
*Remove and replace tint on rear window and probably side windows too.
*Shorten shift throw if it can be done.

I'll leave list as it is now until I catch up with it.