Hello. I'm new to this forum and D-50 ownership (kinda) lol. When I was in high school I drove a 1990 Dodge D-50 2wd reg cab 5spd and if I remember right it had a 2.4L EFI. Might be wrong on that I'm not to familiar with these motors yet. Of course I was young and stupid and didn't appreciate the truck as much as I should have and ended up selling it for next to nothing. Now years later I recently purchased a 1988 Dodge Power Ram 50 Sport Ext cab 4wd 5spd(km145?) 2.6L(G54B?). I bought it pretty cheap and the truck is in fairly good condition. As far as I can tell I have the head that has the jet valves and from what I read they are not very good and tend to crack. The truck also needs a new intake manifold. My plans for this truck is to beef up the motor some (nothing to over the top). I was looking into getting a weber carb and a intake manifold to would be better to use with a weber carb. If nothing is available I would use the stock intake manifold. I already need a new intake so thought id upgrade with the carb. I was also looking into getting a upgraded head that would perform better and more reliable. When I changed the head I would have the bottom end done. So anyways here's what I'm getting at... What weber carb do you guys suggest for a basically stock motor that eventually have a upgraded intake/head granted I can find them? What kind/where can a stock or better intake manifold be found? What heads are interchangeable with the 1988 2.6L? Sorry for my ignorance. Ill try to catch on quick.ig