Results 1 to 4 of 4

Thread: Oil Pressure Thread Sizes

  1. #1

    Array
    Status
    Offline
    Join Date
    05-25-2013
    Posts
    35
    Location

    Winston Salem N.C.
    Vehicle

    1988 Mitsubishi Mighty Max
    Engine

    G63B

    Oil Pressure Thread Sizes

    HELLO EVERYONE, I have a 1988 Mighty max with a 2.0. I am going to put a weber carb on and electric fuel pump with it wired to a oil pressure switch. Can you tell me what length pipe nipple and thread size I need. Also what size tee do I need on all three sides. I know alot about Fords and Chevy's but am just learning about this truck. Thank's

  2. #2




    Array
    Status
    Offline
    Join Date
    03-20-2011
    Posts
    4,780
    Location

    Pittsburgh, PA
    Vehicle

    1980 Dodge D-50
    Engine

    G54B
    See my PM to you.
    Pennyman1
    The best Dodge that Dodge never made
    Living the D-50 lifestyle since 1980

  3. #3



    Array
    Status
    Offline
    Join Date
    07-24-2012
    Posts
    2,359
    Location

    Washington State
    Vehicle

    1986 Mitsubishi Mighty Max
    Engine

    G63B
    LOL 1949PanRider, Once we gradgeate from Mitsubishi Mekanics skool, they let us ride in the short bus.

    Got any photos of your bike? Even some of that Red Hot Rod too!! I'm sure we all would like to see'em if you would like to show them :.)
    *BUILT & OWN*
    '86 Mitsubishi Mighty Max ("Mitsy") The Build History

    "1st Gen Japanese Vehicles"
    '86 Mitsubishi Mighty Max -(Purchased '87)
    '89 Toyota MR2 GT -(Purchased '08)
    '74 Toyota Celica GT -(Purchased '76-Sold '12)
    "Ford Thunderbirds"
    '85 5.0 302 Thunderbird -(Purchased '14)"Muscle Car"
    '88 3.8 V6 EFI Thunderbird -(Purchased '19)

  4. #4

    Array
    Status
    Offline
    Join Date
    04-09-2016
    Posts
    35
    Location

    VA
    Vehicle

    1988 Mitsubishi Mighty Max
    Engine

    I.D.K.?
    Hi What was the answer to this question.... I am trying to wire up an after market oil and water pressure sensor and nothing 1/8 seems to work... they just dont fit... I order 1/8 tees from amazon no go... I went to the hardware store got some 1/8 plumbing junk... no go...

    Same for the extra port on the coolant connection only thing that fits is the Mitsubishi stuff that is used to plug the hole... 1 hour project has turned in to a 2week lost cause...

    any help would be welcomed...


    Quote Originally Posted by 1949panrider View Post
    HELLO EVERYONE, I have a 1988 Mighty max with a 2.0. I am going to put a weber carb on and electric fuel pump with it wired to a oil pressure switch. Can you tell me what length pipe nipple and thread size I need. Also what size tee do I need on all three sides. I know alot about Fords and Chevy's but am just learning about this truck. Thank's

Tags for this Thread

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •