Results 1 to 2 of 2

Thread: RAM 50 Motor swap question

  1. #1

    Array
    Status
    Offline
    Join Date
    12-13-2012
    Posts
    1
    Location

    Lynden, WA
    Vehicle

    1989 Dodge Ram 50

    RAM 50 Motor swap question

    Hello all! Newbie here and I have a question. I just purchased a 1989 Ram 50 with a spun crank. Motor is a G54B type K03. What motor could i replace this with that will bolt to the original bell housing or what motor/trans would be the easiest to do a full swap. Thanks!

  2. #2



    Array
    Status
    Offline
    Join Date
    03-16-2011
    Posts
    3,614
    Location

    Sacramento, CA
    Vehicle

    1979 Dodge D-50
    Engine

    Chevy V6
    Welcome to the site.
    If you have a wide block engine, and you should seeing you have an 89 there are several ways you can go. You can start by looking in the Wiki and getting an idea of what you have. And what will fit. http://www.mightyram50.net/vbulletin...e+and+markings

    Once you have an idea of just what you have, because lord knows we have see all kinds of things stuck in there, we can work forward. But the big factor is going to be just how much money you want to spend. If I was you, I would drop in the same engine with some upgrades to it. If done correctly you will get more HP and torque with out ripping up other parts and spending a boat load of money on it.
    Members come and members go, But the board keeps track of them.
    Check out the Fear Monger by
    clicking HERE.

    The MightyRam50 site is sponsored in part by On Site Concrete Inc.

Tags for this Thread

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •