Hey what methods are people using to lower their first gen L200s/ Ram 50s?? At the moment I have had 2" lowering blocks installed and have had the front springs cut but by cutting a whole coil out this has dropped the front end too low still leaving me with the raised rear end look... I want to achieve a low but level look. I have looked for lowered springs on sites in Australia "King Springs" but to no avail, was wondering if the front springs of the first gen L200s were the same as lowered springs for later models or other similar models in the Mitsubishi family ie Sigma etc. Also cut springs are a little more bouncier and cant imagine them lasting as long as properly set lowered springs. any help would be much appreciated! Cheers Dan.