Help,
I have a 1986 Ram 50 that will not start, I replaced the coil about two weeks ago because it tested out bad.The ohm readings were wrong and so were the voltage readings,the truck ran great for about two and a half weeks. Friday I went out to it turning over and not starting,there is no spark at the coil or the distributor.With the key in the run position I have power on both sides of the coil,the ballast resistor and on positive side of the ignitor ( Ignition module ) in the distributor. I am out of ideas,going out to retest the ohm readings and voltage off the coil in the morning.
Thank You in advance.