Results 1 to 3 of 3

Thread: How to remove the transmission input shaft bearing?

  1. #1

    Array
    Status
    Offline
    Join Date
    10-06-2012
    Posts
    10
    Location

    Idaho
    Vehicle

    1984 Dodge Power Ram 50
    Engine

    4D55-T

    How to remove the transmission input shaft bearing?

    I need to replace the input shaft bearing on a new transmission I got for my d50 before I install it. Only problem, is I can't figure out how. I removed both snap rings, but it still won't come of if the shaft. Do I need a puller, or is it pressed on the shaft? It is the km145 that came behind the 2.6 in the 4x4 application. Thanks

  2. #2



    Array
    Status
    Offline
    Join Date
    03-26-2011
    Posts
    1,507
    Location

    Vacaville, CA
    Vehicle

    1989 Mitsubishi Mighty Max
    Engine

    4G63-T
    Im pretty sure its pressed in and you need a npuller, thats how my grandfather did one of my trannies when i got my first truck.

  3. #3




    Array
    Status
    Offline
    Join Date
    03-20-2011
    Posts
    4,851
    Location

    Pittsburgh, PA
    Vehicle

    1980 Dodge D-50
    Engine

    G54B
    It will require a puller to remove the bearing and a sleeve or length of pipe to reinstall the new bearing. Shouldn't be to hard to do.
    Pennyman1
    The best Dodge that Dodge never made
    Living the D-50 lifestyle since 1980

Tags for this Thread

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •