overheating???

[onelozu]

First thing I would do is replace that thermostat. Then check waterpump belt tension. From there I'd look for coolant leaks like any clamps that aren't tight, or that stupid o ring around that pipe.

well,i pulled the t-stat,the belts are tight,and i didnt see any leaks,it holds the water good,just overheats.. how could the o ring make it overheat?

Maybe you have an air bubble trapped in the system somewhere, that could make it overheat.

how would i go about getting an air bubble out? i tried burping the system but it didnt do anything

[4doorciv]

The o ring was an example of a place to look for leaks.

[onelozu]

The o ring was an example of a place to look for leaks.

oh lol cause when i changed the pump i left the old o ring cause i didnt realize that i had a new one,but it doesnt leak..

also,instead of the gasket i used permatex,think i coulde accidently covered up anything that wouldnt let the water flow right?? before i have to go pull the truck all apart again just to see if thats possible

[4doorciv]

On that note, the new gasket only covers the perimetor of the water pump. Bit the entire thing. How much did you put on?

[crvtec90]

Make sure your radiator isnt clogged. With the truck up to temperature use your hand to feel the air coming across the radiator....Dont get hit by the fan!. You should feel warm-hot air being blown by the fan. If the fan clutch is just free spinning you might not be getting enough air to cool the radiator.

[l.k.]

all the above is about all i could think of as i was reading.

good luck and keep us posted on progress in solving this issue

[onelozu]

On that note, the new gasket only covers the perimetor of the water pump. Bit the entire thing. How much did you put on?

i covered only what the gasket covered

Make sure your radiator isnt clogged. With the truck up to temperature use your hand to feel the air coming across the radiator....Dont get hit by the fan!. You should feel warm-hot air being blown by the fan. If the fan clutch is just free spinning you might not be getting enough air to cool the radiator.

ill try that in the morning,also it seems that when the truck starts getting warm the water in the radiator stops moving