Results 1 to 7 of 7

Thread: need some timing help

  1. #1

    Array
    Status
    Offline
    Join Date
    08-16-2012
    Posts
    5
    Location

    Fresno CA
    Vehicle

    1988 Mitsubishi Mighty Max

    need some timing help

    88 mighty max 2.0 carb engine rebuild

    Do I line the camshaft sprocket up with the top line in the picture (the line where the valve cover meets the head) or the bottom (the line inside the head). Confused because the haynes manual is not very specific and shows the camshaft sprocket level when timed correctly. But if you line it up with the bottom line in the picture, the camshaft sprocket is tilted counterclockwise. I'm having some issues getting the timing to 8 degrees.

    ???


  2. #2



    Array
    Status
    Offline
    Join Date
    03-26-2011
    Posts
    1,507
    Location

    Vacaville, CA
    Vehicle

    1989 Mitsubishi Mighty Max
    Engine

    4G63-T
    Line it up to the top line where the head and block meet and you should have no problem getting it timed right.

  3. #3

    Array
    Status
    Offline
    Join Date
    08-16-2012
    Posts
    5
    Location

    Fresno CA
    Vehicle

    1988 Mitsubishi Mighty Max
    that is where I have it at. I cannot get to 8 degrees. I'm to far to the right of 8 or if I move it one tooth the other way I'm too far to the left. It will start but immediately dies when I raise the rpms

  4. #4

    Array
    Status
    Offline
    Join Date
    08-16-2012
    Posts
    5
    Location

    Fresno CA
    Vehicle

    1988 Mitsubishi Mighty Max
    when I move the distributor

  5. #5


    Array
    Status
    Offline
    Join Date
    07-27-2011
    Posts
    263
    Location

    Nyssa, Or
    Vehicle

    1982 Dodge Power Ram 50
    Engine

    G54B
    did you make sure #1 cylinder at top dead center and rotor is set accordingly. just saying cause those timing marks on the gears could be off by couple of teeth.

  6. #6

    Array
    Status
    Offline
    Join Date
    08-16-2012
    Posts
    5
    Location

    Fresno CA
    Vehicle

    1988 Mitsubishi Mighty Max
    yes #1 tdc, I'll try putting the cam sprocket on the lower mark and see what happens

  7. #7


    Array
    Status
    Offline
    Join Date
    07-27-2011
    Posts
    263
    Location

    Nyssa, Or
    Vehicle

    1982 Dodge Power Ram 50
    Engine

    G54B
    check to see where the cam is in relation to #1 cylinder at TDC, it should be one of two positions just begining to open #1 intake or about 180 out on flat of lobe indicating compression stroke.

Bookmarks

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •