Ok, so first I tried to use the "drill in the speedo plug" method... clearly it would have taken a thousand years to add the number of miles I needed my ODO to show... Because I didn't want my grandchildren to be the first people to enjoy the new gauges, I decided to take the gauges apart and fix things that way... #really?!

Long story short, I got to the point where I had taken both clusters apart to swap odos, I had taken the tach cluster odometer itself out and was trying to turn the numbers to match what I needed. I felt like I was in an Indiana Jones movie or I was trying to decipher an ancient stone mason's key... It was like a Rubix Cube gone bad...

What's more, when I finally figured out how to set the numbers, and I got the odometer numbers back in the odometer housing, I missed one detail that made the numbers point down a little in the bezel, and I almost lost the "baby-small" retainer clip that holds the numbers in the housing. Gratefully my friend was here and eventually found it. (I was already going to the truck to try to swap the odo from the original cluster.) Seeing the old odo showed me how to align the new one though, had to take to small clip off again, but i learned from my mistakes and kept it close this time. (*note* friends don't let friends take apart small things on carpet)

When I put everything back together this time, the numbers lined up, everything was properly adjusted and we were finally good to go. I put the gauges back in the truck, and when I was able to test drive, the numbers roll over as the should. (*I'm glad they didn't roll backwards, or have bigger numbers roll before smaller numbers)

So, now the gauges are in and the numbers are true and I can put this chapter of the build to rest...#whew!

I'm not sure what will be my next mod, but I'll definitely keep you posted.
Thanks for checking me out.
Stay "tuned"!

2012-04-26_20-35-25_964.jpg2012-04-26_21-02-24_844.jpg