timing problems

[cubcadet621]

Well I cleaned up my mess from the mishap of leaving a ratchet on tge crankshaft bolt and had it running last night but it didn't seem like it was exactly right so i re read the book on setting the timing and originally I put a paper clip in the little plug on the wheel well when i set the timing. After reading again it said it should be grounded ....so i did that and checked timing again and it won't even run at all now. Everything seems dead on but my fear is maybe that wasn't the correct plug to ground...

[camoit]

Check the fuses. I remember seeing a post from LSR-Mike that he had a picture of the plug to ground out.

[cubcadet621]

I checked all fuses under the dash and the one fuseable link i found. I double and triple checked base timing and it will not fire off. I checked voltage at the coil with the key turned on and have voltage there im getting fuel can the base timing not be set w/o that ignition jumped out and grounded? It was running prior to this but i didn't jump that out so I wanted to get it closer with a light and that circut jumped. Sorry guys I'm just lost at this point

[cubcadet621]

I spoke to soon cam I was looking over the wiring diagram and missed the three big inline fuses and found the 20amp popped so im going to pray thats my problem!fingers crossed!

[LSR Mike]

for those who missed it.

[cubcadet621]

Thanks mike! I wish some of the pros lived in SC! Lol