-
Head swap
Hi all its been a while . I was active at mightyram50.com.
I have a 89 ram50 with a 2.6l g54b Head with carb and jet valves.
I need to replace the head gasket and bolts. I want to get away from jet valves .
I've found a 2.4l fi mighty max head. Will this head work on my 2.6l?
I talked to the seller he said I could use carb or injectors with the head by changing the manifold. What would be involved in converting my ram50 to fi?
Thanks for your time.
zzion
-
I know you can put a G52 on a G54B. You have the late model head correct? small cam bore VS the early with the large cam bore, if so I would get one from that head place in Florida, and on ebay I can't remember the name of them. But then you don't need to mes with manifolds or other problems that come up.
http://www.mightyram50.net/phpbb3/vi...p?f=105&t=1181
-
No it will not work, the g63b(2.0) and 4g64(2.4L) will swap since they are the same series of engines, and the g54b(2.6L) and g52b(old 2.0) will swap I believe.
-
Bachelors Degree
Array
2.6 has a timing chain while the 2.4 has a belt
-
Senior
Array
if your looking at a new head then check with Clearwater Cylinder Heads. they come fully assembled and you can get them without jet valves and they are $400. that is where i got the head for my motor.
Tags for this Thread
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules
Bookmarks