Printable View
OK at another stand still on this build... Im trying to figure out how you guys supplied Power to your ecu.... So far I wired up relays for the pump and fan and have everything mounted just need to run fuel lines and weld the exhaust...
Attachment 6244Attachment 6245Attachment 6246Attachment 6247Attachment 6248
This is how Mitsubishi did it.
Attachment 6272
Not sure, but that looks like a freeway map of LA California.
I powered my mpi relay from the two wires that went to the ballast for the coil on the stock motor. and I think I also took power from the hot wire to the ignition switch. I cant exactly remember as its been a while since I did my swap.