Anybody out there adapt one of the Holley sniper efi systems to a gen 2 ram 50 2.6 manifold, if so what adapters did you use to adapt it and what did you do for throttle cable setup.
Printable View
Anybody out there adapt one of the Holley sniper efi systems to a gen 2 ram 50 2.6 manifold, if so what adapters did you use to adapt it and what did you do for throttle cable setup.
The sniper EFI has been talked about on the site but I think after reading up on cost it was deemed not worth it. I don't think there's a specific adapter plate for it but something like this might be a way -
https://www.ebay.com/itm/Adapter-Pla...kAAOSwmphaKNJ-
You need the sniper kit, a high pressure fuel pump and the adapter plate. The throttle cable set up should actually be the easy part on this.
Do not think that pattern will work, on my 2.6 manifold the bolt spacing is 1.75" x 3 3/16" (44.45 x 81)