Printable View
So I got the heads back on, & I have the head bolt torque sequence, but I'm getting
a lot of different specs & procedure....
Some say torque then loosen, re tighten. With stretch type bolts I dont like the sound of that....
Who's got the skinny on proper sequence, torque, etc.????
Tanks brus, I really gotta get a book for this truck....
In looking for cylinder head bolts for a 2.4 I found bolts for the 6 cyl available. I am thinking that they are "torque to yield" and should be replaced. I did not find bolts for the 2.4
I’ve reused them on several of my 3.0 12 valve motors I’ve had to do head gaskets on. I just torque in two stages. I do 50-60% of the required and then come back after and do them all the way. Been fine so far. Just follow the correct sequence.
Yeah I was hoping you mite have that correct sequence & spec for me there killer,
I'm lookin on google and it seems that every vehicle the various 6g's were in have a different spec & sequence....
I need you macGuiver, here's what I've got:
Attachment 22880
Torque to 80 ft lbs......
Is this correctimundo ????
....anybody?
....anybody?
That sounds about right. Sorry I’m not home to check my manual.
kk awesome. that feels bout right after torqueing them just now.
thanks again for the guidance.