Page 1 of 11 123 ... LastLast
Threads 1 to 25 of 259

Forum: Tuning & Smog

Is your baby not running right, or just wont start, pinging, smoking, or you are really stuck? Here is the place for you.

    • Replies: 23
    • Views: 7,461
    05-03-2016, 10:11 AM Go to last post
  1. Sticky Thread Sticky: Vacuum Diagram

    Started by blessedguy, 12-15-2012 01:25 PM
    2 Pages
    1 2
    • Replies: 40
    • Views: 12,274
    06-19-2015, 05:55 PM Go to last post
    • Replies: 19
    • Views: 206
    12-02-2016, 05:25 PM Go to last post
    • Replies: 6
    • Views: 100
    11-29-2016, 12:45 AM Go to last post
  1. Stupid quick question...

    Started by Rymar Garage, 09-22-2016 07:48 PM
    • Replies: 23
    • Views: 658
    11-03-2016, 09:19 AM Go to last post
  2. Upgrading a 2.6L to CFI

    Started by markmakeitso, 10-22-2016 06:25 PM
    • Replies: 14
    • Views: 249
    10-29-2016, 09:10 AM Go to last post
  3. poor MPG's lots of carbon at the tail pipe.

    Started by 85Ram50, 10-26-2016 05:19 PM
    • Replies: 6
    • Views: 118
    10-28-2016, 07:44 AM Go to last post
  4. Unhappy 89 Carbureted 4G52 Stalling Out

    Started by AaronB31, 10-27-2016 12:48 PM
    • Replies: 4
    • Views: 63
    10-27-2016, 06:47 PM Go to last post
  5. G63b dies when giving gas

    Started by mikewarme, 10-23-2016 06:11 PM
    • Replies: 2
    • Views: 77
    10-24-2016, 02:02 AM Go to last post
  6. Secondary not opening (G54B), no vacuum?

    Started by Dude13450, 08-21-2016 07:36 PM
    • Replies: 3
    • Views: 184
    10-22-2016, 05:33 PM Go to last post
  7. Cannot get this 4g64 to run right

    Started by DroppedMitsu, 08-21-2016 04:00 PM
    • Replies: 6
    • Views: 341
    10-22-2016, 01:00 PM Go to last post
  8. Dreaded Mikuni Carb question....

    Started by Dweezil8675, 10-17-2016 12:09 PM
    • Replies: 11
    • Views: 198
    10-19-2016, 08:57 PM Go to last post
  9. 88 G63B Max not starting after sitting

    Started by Version6, 10-11-2016 12:33 PM
    • Replies: 4
    • Views: 134
    10-19-2016, 08:03 AM Go to last post
  10. Will Not Pass Emissions I have DEG report

    Started by jerry wonder, 10-05-2016 06:21 PM
    • Replies: 1
    • Views: 114
    10-06-2016, 07:39 AM Go to last post
  11. Exclamation well back @ it again with the run on problems

    Started by jamesw, 08-29-2016 03:50 PM
    • Replies: 15
    • Views: 381
    09-15-2016, 02:27 PM Go to last post
    • Replies: 4
    • Views: 252
    09-12-2016, 05:19 PM Go to last post
  12. 1991 2.4 crankshaft gears

    Started by drewtbro, 09-07-2016 10:40 AM
    • Replies: 1
    • Views: 143
    09-10-2016, 06:30 AM Go to last post
  13. Mikuni-Solex Carb repair

    Started by blue72super, 08-31-2016 01:27 PM
    • Replies: 1
    • Views: 219
    08-31-2016, 01:31 PM Go to last post
  14. Truck randomly white smokes

    Started by t97, 03-01-2016 09:02 PM
    • Replies: 7
    • Views: 533
    08-26-2016, 02:29 AM Go to last post
  15. Screwed up timing, I Think..

    Started by chaoticdopey, 06-04-2016 08:28 PM
    3 Pages
    1 2 3
    • Replies: 56
    • Views: 2,991
    08-19-2016, 05:06 AM Go to last post
  16. Hard start when cold with check engine light

    Started by dannyboy, 08-17-2016 07:02 PM
    • Replies: 4
    • Views: 173
    08-18-2016, 09:53 PM Go to last post
  17. Question run on after shut off problem

    Started by jamesw, 08-09-2016 04:17 AM
    • Replies: 8
    • Views: 378
    08-13-2016, 03:50 PM Go to last post
  18. Failed AZ emissions... Weber Carb

    Started by haruman, 07-18-2016 10:57 AM
    • Replies: 14
    • Views: 691
    07-27-2016, 02:43 PM Go to last post
    • Replies: 4
    • Views: 278
    07-12-2016, 05:18 PM Go to last post
  19. New to site, problems with mighty max

    Started by 88maxine, 06-14-2013 12:45 PM
    max, mighty, problems, site
    • Replies: 14
    • Views: 7,552
    07-06-2016, 05:11 PM Go to last post
    • Replies: 0
    • Views: 185
    06-23-2016, 11:37 AM Go to last post
  20. Weber choke not opening fully

    Started by Wote, 02-03-2016 12:28 AM
    • Replies: 20
    • Views: 1,122
    06-22-2016, 10:49 AM Go to last post

Page 1 of 11 123 ... LastLast

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •