weber carb adapters

[mscoles]

Does anyone make a one piece carb adapter for the ram 50 to weber.

Thanks,

[geezer101]

https://www.ebay.com/itm/MITSUBISHI-PAJERO-WEBER-32-36-DGV-ADAPTOR-2000-2600-1970-1988-Part-10-112/152653225764?epid=720277569&hash=item238ad75f24:g:ATkAAOSw9NhbEm78

:thumbup:

[Salteen]

https://www.piercemanifolds.com/category_s/100.htm

[SubGothius]

If your intake manifold has that odd dogleg spur off the carb mounting face (for EGR? And I think only some years of 1st Gen had it?), the 2-piece sandwich kit from Redline (US) is the only one I know of with provision for that.

Otherwise, I've found a couple alternatives that seem like they have the same bolt pattern as our stock Mikuni:

Trans-Dapt 2107 (https://www.hedman.com/product-detail/2107) - Note what may appear to be two pieces are actually a single cast piece with flanges connected by a riser pipe, which I gather should theoretically improve torque somewhat. Pretty sure I've seen pics on this forum of at least one Weber swap using this adapter.

Redline 99004.300 (https://www.ebay.com/itm/192704121501) - The only low-profile alternative I'd seen (before Geez linked that nice Aussie one here), but note the cast-in ramp under one barrel making a sharp transition to adapt the barrel spacing, which seems likely to impair performance somewhat, but I reckon could also improve emissions with greater turbulence helping blend the air-fuel mix. I'm also not entirely sure the cast-in barrels at the manifold face would be well-sized and -spaced for our manifold, since we're an off-list application for this adapter.