Parts go where?

[BJH324JH]

So, I was taking apart the transmission/transfer case and I thought I would remember where the parts would go. Yea, that didn't work out okay. I have these parts left and need help figuring out where they go:
20321
I believe there was two of those pill looking things, not sure though.

Also, did I put those rods in place the correct way? The rods can be rolled pin both ways, not sure if I rolled pin them in correctly:
20322

[geezer101]

Image A - opposing sides of the gearbox housing. They are the selector retainers (2 shorter bolts with springs) Drop a ball bearing into each hole and install the bolts (the bearings go into the selector rod notches to keep it in gear). Now the other longer rod with the spring is installed from inside the gearbox...but I can't remember where :rolleyes: Got a feeling it goes into a housing on the end of a selector rod.

[BJH324JH]

Image A - opposing sides of the gearbox housing. They are the selector retainers (2 shorter bolts with springs) Drop a ball bearing into each hole and install the bolts (the bearings go into the selector rod notches to keep it in gear). Now the other longer rod with the spring is installed from inside the gearbox...but I can't remember where :rolleyes: Got a feeling it goes into a housing on the end of a selector rod.

I think this is where the parts may go:
20328
20329

I think the pill looking piece goes in the middle as shown in the picture.

[geezer101]

I think that looks right. There should be a pdf in the manuals section you can refer to to double check.