Reverse Switch Ball Specs

[Chyrio]

As requested by Geezer I did my best to get the specs for the little metal ball for the reverse switch. I don't have calipers but I tried to use my little multi measurement thing to give you guys a good idea. In the 5/16ths hole and 8mm the ball is just big enough that it slides in and out of the hole with no resistance.
19427
19428
This measurement is in millimeters so as you can see its like right in the middle between 5 and 10mm
19429

[geezer101]

:clap: bravo. With pictures...and everything. And as I suspected they are the same size bearings used in old school 1 piece cranks (10 ball cage bearings) so, for for a few bucks you'd get a handful of them. The actual size in mm is 7.94 (for anyone who is about to look it up)

[85Ram50]

Thank You Chyrio! Now I just have to find an 8mm ball and figure out where the 5/16 ball that did not come out is :)

[BJH324JH]

Thanks Chyrio for taking the time to make this thread. You are awesome! Just to add to the thread, here is measurements taken with a digital caliper:

Millimeters:
19430

Inches:
19431