2 gen engine question

[GetIt1]

Hello everybody, i've bought 93 MM with blown engine. 4G64 8V SOHC - 5MT - RWD
Question is, from what car i can buy engine?
I'm from Russia, and nearby nobody has any expirience with that model.
Does the engine from Mitsu Delica would fits good?
Sorry for my poor English)

[LSR Mike]

the 4G64 has 2 major variants, Narrowblock and WideBlock, The trucks (RWD) got Wideblocks (13 1/4 inches) and Cars (FWD) got Narrowblocks (12 1/4inches). This refers to the with of the Bellhousing where the engine meets the transmission.

the link below is to a list of the Mitsubishi motor applications.

http://www.roadraceengineering.com/mitsumotorapplications.htm

The other major difference is 6 bolt flywheel (1st generation) and 7 bolt flywheel (2nd generation) you have a 2nd generation 7 bolt.

sorry the Delica doesn't show up on the list.

[GetIt1]

Thanks!
Also 've seen here pic of sizes wideblock engine, but couldn't find now(

[GetIt1]

Also, were i can find all parts numbers for engine rebuild,
our spare sellers doesnt have catalogue for MM((

[LSR Mike]

Check out the 216 Manuals post also...

http://www.mightyram50.net/vbulletin/showthread.php/3845-Mitsubishi-ASA-Online-CAPS-Factory-Service-Manuals-etc

[GetIt1]

Thanks
Also 've seen link for Great Wall Hover russian forum,
trying to find how will suits chinese engine)

[GetIt1]

Folks)
My attemp to find engine faults, so i've started to rebuild my own
But have 1 question, need new head
Could i buy any sohc head from 4G64?

[LSR Mike]

I am not 100% certain that a 6 bolt Motor head will bolt up to a 7 bolt motor. Most of the changes were on the block, so it "should be possible"
best bet is to go like for like if you can.

also here is another Mitsubishi resource. I mostly about the DOHC variety but most of it applies to the SOHC also.

http://www.vfaq.com/index-main.html

[mitchi]

I just installed a head from a 7 bolt on my 6 bolt, they are the same heads.