royster
03-01-2014, 09:06 AM
Many's the time I needed to look at a photo to see what placement was proper. I offer the following photos of my own 4G64, absolutely stock and all components are in their proper places.
The only contention is the placement of the ignition wires: in these photos they go over the radiator hose. I have since opted to place them under the hose, to minimize subjecting them to heat.
Identification Tag on Firewall [v] (top of photo under red v) - Tells you your engine number (i.e. 4G64) and original paint code
8458
General Engine Layout
8459 8460
8461 8462
Timing Mark On Cylinder Head
8463
Engine Layout
8464 8465
Arrow points to Silent Shaft Access Bolt
8466
Oil Pump-Side Silent Shaft Access Cap [photo by Camoit]
8467
Ignition Timing Jumper Connector Location
8468 8469
A variety of information is also available HERE (http://www.mightyram50.net/vbulletin/showthread.php/2956-Roy-s-Garage-90-2-4-4G64-5-spd-D-50)
The only contention is the placement of the ignition wires: in these photos they go over the radiator hose. I have since opted to place them under the hose, to minimize subjecting them to heat.
Identification Tag on Firewall [v] (top of photo under red v) - Tells you your engine number (i.e. 4G64) and original paint code
8458
General Engine Layout
8459 8460
8461 8462
Timing Mark On Cylinder Head
8463
Engine Layout
8464 8465
Arrow points to Silent Shaft Access Bolt
8466
Oil Pump-Side Silent Shaft Access Cap [photo by Camoit]
8467
Ignition Timing Jumper Connector Location
8468 8469
A variety of information is also available HERE (http://www.mightyram50.net/vbulletin/showthread.php/2956-Roy-s-Garage-90-2-4-4G64-5-spd-D-50)